0

Out of 0 Ratings

Owner's of the ADTRAN Switch NETVANTA 1200 POE gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 76
 
NetVanta 1000/1000R Series Hardware Installation Guide Physical Descriptions
61200500L1-34N Copyright © 2008 ADTRAN, Inc. 31
NetVanta 1524ST Shipping Contents
Each NetVanta 1524ST unit is shipped in its own cardboard shipping carton. Open each carton carefully, and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in transit,
immediately file a claim with the carrier and contact ADTRAN Customer Service (refer to the Repair and
Replacement section of the Support page on the ADTRAN website at http://www.adtran.com/support).
Domestic shipments of the NetVanta 1524ST include the following items:
NetVanta 1524ST base unit
AOS Documentation CD
A detachable power cable with a grounded, three-prong plug
Quick Start Guide
Warranty card
International shipments of the NetVanta 1524ST include the following items:
NetVanta 1524ST base unit
AOS Documentation CD
All necessary power cords
Quick Start Guide
Warranty card
NetVanta 1524ST Front Panel Design
The NetVanta 1524ST front panel is shown below. Table 1 on page 33 describes all of the LEDs, and
Appendix A on page 67 shows the connector pinouts.
NetVanta 1524ST Front Panel Features
10/100/1000BaseT Ethernet Interfaces
The NetVanta 1524ST front panel contains 24 10/100/1000BaseT Ethernet interfaces (RJ-45). These
interfaces are consecutively numbered 1 through 24, from left to right, with the numbers screened
directly above each port. Status LEDs for each of these interfaces are located directly over these
numbers.
SFP Slots
The NetVanta 1524ST front panel contains four standard SFP slots for fiber connectivity. These
interfaces are numbered 21 through 24. Status LEDs for each of these slots are located directly over
these numbers.
Status LEDs
The status LEDs are located to the lower left of RJ-45 port 1. The STK LED indicates whether the unit
is a member of a stack. The
STAT LED indicates the unit’s status.
Figure 21. NetVanta 1524ST Front Panel Layout