0

Out of 0 Ratings

Owner's of the Bogen Telephone UTI1 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 20
 
13
Tones
Pre-Announce/Confirmation Tone
This tone can be set to be heard at the speakers being paged or the calling telephone or both. It is either a chime
or beep (default).The pre-announce/confirmation tone can also be inhibited. See System Programming to change or
inhibit this tone.
Tone Trigger
This tone is activated when the TN and C terminals are shorted together.This tone has the second highest priority
after override. Several tone options are available.
2 - 7 Second Tone Burst - This is a tone burst that, once a momentary closure is detected at the tone trigger input,
will sound for the set duration one time.The UTI1 will not respond to the tone trigger input while the tone is in
progress.If the closure is still present at the tone trigger input upon completion of the tone, then the UTI1 will not
sound the tone again until the closure is removed and applied again.
Tone Follow Contact -This is a tone burst that will sound continuously as long as a contact closure is present at
the tone trigger input.
Double Chime Tone - This is a chime tone that will sound twice when a closure is detected at the tone trigger
input.The UTI1 will not respond to the tone trigger input while the tone is in progress. If the closure is still present
at the tone trigger input upon completion of the tone, the UTI1 will not sound the tone again until the closure is
removed and applied again.
Chime Tone Follow Contact - This is a chime tone that will sound continuously as long as a contact closure is
present at the tone trigger input.
Slow Whoop Follow Contact - This is a slow whoop tone that will sound continuously as long as a contact closure
is present at the tone trigger input.
Override Tone
This tone is produced when override is activated. It produces a quad beep pre-announce tone that can be enabled
or inhibited. (The default is inhibited). See System Programming to enable the tone.
Setup Tone
This tone can be activated only when the system is in Program mode (set with Run/Program switch). It is an
interrupted tone which can be used by the installer to check speaker operation, set operational level of speakers.
See System Programming to enable the tone.
Note: The volume level of all of the above tones are controlled by the TONE VOLUME control. All tones play at the same
level. Clockwise rotation of the control increases the level. Counterclockwise rotation of the control decreases the level.
Reference
How To Page
1. Dial the paging access number for your telephone system.
2. Listen for the confirmation tone if enabled.
3. Make the page and hang up when finished.
Priority Levels
The following is a list of the priority operation of the UTI1.
Highest Override
Tone Trigger
Voice Page
Night Ring
Lowest Background Music