5.0

Out of 1 Ratings

Owner's of the Bushnell Binoculars Night Vision 26 gave it a score of 5.0 out of 5. Here's how the scores stacked up:
  • Reliability

    5.0 out of 5
  • Durability

    5.0 out of 5
  • Maintenance

    5.0 out of 5
  • Performance

    5.0 out of 5
  • Ease of Use

    5.0 out of 5
of 27
 
6
CARE AND MAINTENANCE
Your Bushnell Night Vision device was designed to provide many years of reliable service. To ensure that you get the most
enjoyment out of your Night Vision device, always obey the following warning and precautions:
• Do not point this device toward any light source greater than 1 lux such as car headlights, for an extended period of time.
• This device utilizes an internal flash protection system which minimizes potential damage, but long-term exposure to bright lights
can damage the unit. Any such damage may void your warranty.
• This device was designed to be self-contained. Do not open the body of the device or otherwise attempt to service this device.
• Always store the device in a dry, well-ventilated room.
• Remove the batteries if the device is to be stored for longer than 2 months.
• Keep the device away from any heating and air conditioning vents or other heating devices, direct sunlight, and moisture.
• Avoid dropping or otherwise shocking the unit. Although designed for rugged outdoor use, this device incorporates a sophisticated
optical system, which could be damaged in extreme cases of misuse.
• Clean the optical lenses with professional lens cleaning supplies.
• Clean the exterior of the device with a soft clean cloth.
Class 1 LED product per IEC 60825-1/nov 1993, appendix EN 60825-1A11/oct1996
7
Caution: This device can be used in extreme cold weather. However, when the unit is brought back into a warm
environment, you must wait approximately 5 hours before using the unit again. Damage may occur due to condensation
that may have accumulated on the internal circuitry of the unit.
Spots In The Image
• You may see spots in the image. These vary from device to device and are cosmetic blemishes inside the device. These
are normal for Night Vision devices and are NOT a defect.
TROUBLESHOOTING
Scope will not turn on.
Check that the batteries are installed properly. Replace the batteries with new ones. Check the battery contacts to ensure
they are clean and free of corrosion. Check that the power is in the “ON” position.
Image is not focused.
Adjust the focus on the Eyepieces. Adjust the Objective Lenses. If still no improvement, clean the lenses; they may be
foggy or dusty.
Visibility decreases or disappears.
Bright light sources such as headlights may cause visibility to degrade or disappear completely. Turn the Power OFF
and turn the scope away from the light source. The unit will restore itself in 1 or 2 minutes. Conditions such as fog or
extremely dark environments will decrease visibility.
Scope flashes.
The scope may flash when used in a bright environment. It may also flash during the first few seconds of use in dark
environments.