Chamberlain Garage Door Opener WD962KEV User Manual

5.0

Out of 1 Ratings

Owner's of the Chamberlain Garage Door Opener WD962KEV gave it a score of 5.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    5.0 out of 5
of 48
 
37
MOTION-DETECTING CONTROL PANEL SETUP
LOCK
Activate:
Press and hold the LOCK button for
2 seconds. The command LED will fl ash
as long as the lock feature is activated
and your handheld remote control will not
operate your door at this time.
Deactivate:
Press and hold the LOCK button again for
2 seconds. The command LED will stop
fl ashing and normal operation will resume.
LIGHT
Press and hold the LOCK button until the
garage door opener lights fl ash.* The
time interval is indicated by the number
of fl ashes.
To change the amount of time the garage
door opener lights will stay on:
To cycle through the time intervals repeat
the step above.
NUMBER OF TIMES
GARAGE DOOR
OPENER LIGHTS FLASH
TIME THE GARAGE
DOOR OPENER
LIGHT STAYS ON
1 1 ½ Minutes
2 2 ½ Minutes
3 3 ½ Minutes
4 4 ½ Minutes
LOCK Button
Command LED
LOCK
Button
LIGHT
Button
NOTE: If the
command LED
is continuously
blinking, the
Lock feature
needs to be
deactivated.
Deactivate:
Press and hold the LIGHT button until the
garage door opener lights turn on, then
off again.*
Activate:
Start with the garage door opener lights
on. Press and hold the LIGHT button until
the garage door opener lights turn off,
then on again.*
LIGHT FEATURE
Activate:
Press and hold the ON button until one of
the TTC LEDs light up.
Then press the ON button again to cycle
through the time interval options (the
corresponding TTC LED will light for each
time interval). The garage door opener
light bulbs will blink as confi rmation.
Deactivate:
Press and hold the OFF button until all
TTC LEDs turn off and a beep is heard
from the motor unit.
Temporarily hold door open
(suspend TTC):
Press and release the HOLD OPEN button.
Press the HOLD OPEN button again to
resume normal TTC operation.
ON
Button
OFF
Button
HOLD OPEN
Button
1 Minute
TTC LED
5 Minute
TTC LED
10 Minute
TTC LED
TIMER-TO-CLOSE (TTC)
Command
LED
MOTION SENSOR
Slide the motion sensor switch ON or
OFF.
Activate/Deactivate:
Motion
Sensor
Switch
Motion
Sensor
NOTE: DO NOT enable TTC if operating
a one-piece door. TTC is to be used
ONLY with sectional doors.
* Approximately 10 seconds

   Find Your Products By Category