Dual Car Amplifier XPE2700 User Manual

4.5

Out of 3 Ratings

Owner's of the Dual Car Amplifier XPE2700 gave it a score of 4.5 out of 5. Here's how the scores stacked up:

  • Reliability

    4.67 out of 5

  • Durability

    4.67 out of 5

  • Maintenance

    4.67 out of 5

  • Performance

    4.33 out of 5

  • Ease of Use

    4.0 out of 5
of 12
 
7
XPE SERIES INSTALLATION
Amplifier Connections
Speaker Connections
Connectspeakerwiresobserving
polarity.Theminimumimpedance
loadfortheXPE2700andXPE4700
is 2 ohms stereo and 4 ohms
bridged.Useofloadslowerthan
these is not recommended and
may cause amplifier damage.
TheXPE2700andXPE4700can
bewiredforstereo,bridgedor
stereo/bridgedsimultaneous
operation.
Input Signal Connections
Low Level Input (RCA)
Lowlevel(RCA)inputsignalispreferredforbestperformance.Typicaltrunk-mount
amplifierinstallationsrequirea17-20footRCAcable.Mosttrucksandunder-seat
applicationsrequirea6-9footRCAcable.UsingtwistedpairconstructionRCAcableswill
minimize noise.
High Level Input (Speaker Wire)
Highlevelinputsshouldonly
beusedwhenRCAoutputsare
notavailablefromtheheadunit.
Connecttheheadunitspeaker
outputstothehighlevelinput
connectorasshownbelow.The
blackwire(signalreferenceground)
mayormaynotrequireaconnection
tochassisground-dependingon
your particular installation.
Subwoofer (mono)
Typical Bridged Wiring
(4 ohms minimum)
2 Speakers (stereo)
Typical Stereo Wiring
(2 ohms minimum)
CAUTION
Donotusebothlowandhighlevelinputsatthesametime-connectonlyoneortheother.
XPE2700speakerconnectionsshown

   Find Your Products By Category