APC Battery Charger J25B User Manual

0

Out of 0 Ratings

Owner's of the APC Battery Charger J25B gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 41
 
A/V J Type Power Conditioner and Battery Backup8
Green function - transfer threshold. Configure the master outlet to recognize when the master
device has gone into sleep or standby mode. Configure the delay between when the Master unit turns off
and the peripheral units turn off.
Low battery warning. Set the time at which the unit will provide an audible warning that it almost
exhausted battery power.
Suggested battery replacement date. The Repdate shows the date on which the battery was last
replaced. Update this date if a new battery pack is installed.
Self-test. Select yes to initiate a self-test of the unit. If the test fails, contact APC technical support.
Runtime calibration. Perform a runtime calibration test to completely discharge the batteries, and
recharge them. This allows the unit to accurately predict runtime capacity. This test should be run once a
year, after the unit has been in service for at least one year.
LED and audible alarms test. Perform this test to test the LEDs and the audible alarms on the unit.
Screen saver. Turn the screen saver on or off.
Reset to factory defaults. Reset all settings to the factory default.
MASTER THRES: 25W
PRESS TO CHNG
CON ONDLY: 4 SEC
PRESS TO CHNG
CON OFFDLY: 4 SEC-
PRESS TO CHNG
LOWBATTWARN: 2MIN
PRESS TO CHNG
REPDATE: 3/04/12
PRESS TO CHNG
DO SELFTEST: NO
PRESS TO CHNG
RUNTIME CAL: NO
PRESS TO CHNG
DSPLY-BP TEST: NO
PRESS TO CHNG
SCREEN SAVER: ON
PRESS TO CHNG
RESET->DEFLT: NO
PRESS TO CHNG

   Find Your Products By Category