ACR Electronics Marine Safety Devices SARLink User Manual

0

Out of 0 Ratings

Owner's of the ACR Electronics Marine Safety Devices SARLink gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 22
 
Y1-03-0241A 17
Figure 6 –
Attachment Clip
2. Attachment Clip
The AquaLink™ comes standard with an
attachment clip. To install the clip, simply align the
bottom tabs on the clip with the insert holes
located on the bottom of the beacon. Snap the
clip in place by pressing the top of the clip so that
the two top tabs engage in the two insert holes on
the top of the beacon (see Figure 6). To remove
the clip, push up and back on the top tabs one at
a time to disengage from the beacon.
This clip has been designed to secure your
beacon directly to life jacket webbing straps or
belts to ensure the beacon is close at hand. ACR
recommends that you have a strap on your life
jacket in the shoulder area for attachment of the
PLB. The beacon should hang with the GPS
receiver up (so that the beacon is inverted). This
will give the GPS receiver the best possible view
of the sky. It is also recommended that you try
your life jacket on in the water to see how you
float in it and where to best locate the beacon so
that the beacon is not in the water. You may choose to carry your beacon
in a pocket but you should have a strap installed on your life jacket to
attach the beacon when it is activated. This will leave your hands free
while treading water.
NOTE: ACR recommends that once you have clipped your beacon
in place that you also anchor the beacon with the lanyard to your life
jacket, backpack, etc. to ensure the unit will not be lost if it should
break out of the clip.
NOTE: ACR recommends that once you have clipped your beacon in
place that you also secure the beacon with the lanyard to your life
jacket, backpack, etc. to ensure the unit will not be lost if it should
break out of the clip.

   Find Your Products By Category