Avanti Beverage Dispenser PARTY PUB User Manual

5.0

Out of 1 Ratings

Owner's of the Avanti Beverage Dispenser PARTY PUB gave it a score of 5.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    5.0 out of 5
of 28
 
9
Installation of Your Appliance
• Take the appliance out of its packaging (do not allow children to play with plastic parts, as this can
cause a possible choking hazard).
• Place your Party Pub on a steady and horizontal flat surface, leaving at least 5 inches / 10 cm on
either side so as to allow correct ventilation of the appliance.
• Set the drip tray into the notches provided.
• Install the dispenser handle and the dispensing head to the door, making sure that both end-
pieces perfectly fit together.
• Connect the appliance to the 115V AC power supply
• Screw the piercing pin into the dispensing unit. Make sure that the transparent seal is properly
located on the pin before screwing, otherwise, fit it correctly.
Dispensing unit
Piercing pin with transparent Keg seal
Preparing the keg
Your Party Pub will keep your 5L Keg cool for an almost indefinite period. Once a keg (your Party
Pub is designed to hold up to 2 5L Kegs) has been inserted into the running Party Pub, it will
maintain a nice, cool temperature. Remember to keep your Party Pub out of direct sunlight and away
from any other direct sources of heat.
This appliance is designed for most 5-liter kegs.
Your Party Pub can cool a 5-liter keg from 25°C to 3°C (77º to 38ºF) in 9 hours.
Pre-cooling is not needed if the Party Pub is cooled to a temperature of 38ºF
Your Party Pub is designed to refrigerate a 5-liter keg down to a 3 °C (38ºF) temperature within
10 hours.
Never put a keg into the freezer. The beer might freeze and the keg could burst.

   Find Your Products By Category