Bogen Car Speaker Bogen Communications Car Speaker User Manual

0

Out of 0 Ratings

Owner's of the Bogen Car Speaker Bogen Communications Car Speaker gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 2
 
54-5069-01 Printed in Korea 9904
© 1999 Bogen Communications Inc. All rights reserved.
Specifications subject to change without notice.
Speaker Installation
STEP 1 - Mark the point from which to hang the speaker. Drill
an appropriately sized hole in the wall and insert an anchor. Drive
the screw into the anchor leaving enough of the screw exposed
from which to hang the speaker on. See Figure 3.
NO
TE: Wall baffle speakers should be installed between
8 and 16 feet from the floor depending upon need.
STEP 2 - Make the electrical connections using the 2 screw ter-
minals on the WB1EZ. The recommended amplifier connections
are:
(+) 70V terminal - 70V HOT
(-) COM terminal - 70V COMMON
NO
TE: The speaker will also work perfectly well with these
connections reversed. However, it is important to be
consistent in the wiring of the speakers in the system.
If adjacent speakers have reversed wiring connections, they
will tend to cancel each other’s bass response, thereby
diminishing the sound quality.
STEP 3 - If it is necessary to adjust the volume, insert a thin, flat
blade screwdriver into the access hole at the bottom of the wall
baffle, then turn the volume control clockwise (as viewed from the
bottom of the baffle) to increase the volume. To reduce the vol-
ume, simply turn the volume control in a counterclockwise
motion. See Figure 4.
Figure 3
Figure 4
BACK OF SPEAKER
RECESSED VOLUME CONTROL
Turn in a clockwise motion
to increase volume.
BOTTOM
OF SPEAKER
WALL
ANCHOR
50 Spring Street, Ramsey, NJ 07446
Tel. (201) 934-8500 / Fax: (201) 934-9832
www.bogen.com

   Find Your Products By Category