Furuno Musical Instrument Wind Angle, Course Pilot, Rudder Instrument User Manual

0

Out of 0 Ratings

Owner's of the Furuno Musical Instrument Wind Angle, Course Pilot, Rudder Instrument gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 62
 
5. INSTALLATION
34
5.4.2 Setting up FI-506
Rudder calibration
You can apply an offset to the rudder indication to remove any deviation
from actual and displayed rudder angles.
1. With the rudder centered, press the
W and X keys together until the
instrument starts beeping continuously. The beeping indicates you
have correctly enabled the calibration mode.
2. Use the
W and X keys to move the pointer to the zero position.
3. Press the
W and X keys together again to save the setting and
escape from the calibration mode.
Terminal resistor on/off
The terminal resistor enables/disables connection of the FI-506 to an
NMEA 2000 network, and it is disabled at the factory. To turn the resistor
on or off, press and hold down the BRILL and
W keys together until you
hear a beep. Then, press the
X key to turn the resistor on or off. The
number of beeps indicates ON or OFF. Two beeps for ON, three beeps
for OFF. Press the BRILL and
W keys together to save the setting and
return to normal operation. A beep sounds upon completion.
Synchronization on/off
The data shared within the FI-50 instruments series can be synchro-
nized, so that all data agrees. You can turn synchronization of all data on
or off, or synchronize data by group, A and/or B. For group synchroniza-
tion, instruments having like group synchronization settings are synchro-
nized.
To set synchronization, press and hold down the BRILL and
X keys to-
gether until you hear a beep. Then, press the
X key to select applicable
synchronization setting. The number of beeps and beep duration indi-
cate the setting as shown below. Press the BRILL and X keys together
to save the setting and return to normal operation. A beep sounds upon
completion.
ON: Beep
*1
→OFF
*1
→Beep
*1
A: Beep*
1
→OFF*
1
→Beep
*3
B: Beep
*3
→OFF
*1
→Beep
*1
→OFF
*1
→Beep
*1
→OFF
*1
→Beep
*1
OFF: Beep
*3
→OFF
*2
→Beep
*3
→OFF
*2
→Beep
*3
*1
200 ms,
*2
500 ms,
*3
1000 ms
Factory defaults
Press the and BRILL keys together until you hear a beep, indicating
completion. Press the same keys again to return to normal operation.

   Find Your Products By Category