4.3

Out of 17 Ratings

Owner's of the Brinkmann Smoker 810-7080-K gave it a score of 4.3 out of 5. Here's how the scores stacked up:
  • Reliability

    4.24 out of 5
  • Durability

    4.59 out of 5
  • Maintenance

    4.0 out of 5
  • Performance

    4.44 out of 5
  • Ease of Use

    4.47 out of 5
of 24
 
4
STEP 1
a. Attach wooden handle halves to metal brackets using 8-32 x w"
screws and nuts as illustrated.
b. Attach two handle assemblies to side of smoker body using
10-24 x s" screws and square nuts as illustrated.
c. Attach the three lower support brackets (V-clips) to inside of smoker
body through the three 4" holes that are located about halfway down
the smoker body (lower level). Mount each bracket with notched side
facing up using 10-24 x s" screws and square nuts. Tighten screws
securely.
d. Attach the three upper support brackets (single clips) to inside of
smoker body through the three 4" holes located near the top edge.
Mount each bracket with notched side facing up using 10-24 x s"
screws and square nuts. Tighten screws securely.
STEP 2
a. Attach hinge to inside of smoker body as illustrated. Use
6-32 x 4" screws and nuts to attach hinge to smoker body.
NOTE: Attach the hinge so pin is facing out of smoker as illustrated.
b. Attach door to hinge using the remaining 6-32 x 4" screws and nuts.
Pin Facing Out
Upper support bracket
with notched side
facing up.
Lower support bracket
(V-clip) with notched
side facing up.
7085-K_Gour Elec_Eng-SP.qxd 11/1/07 2:28 PM Page 6