Avanti Beverage Dispenser WDTZ000 User Manual

0

Out of 0 Ratings

Owner's of the Avanti Beverage Dispenser WDTZ000 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 44
 
8
ATTENTION:
If you do not plan to use the water heating function for more than three days, we recommend that you
turn off the hot water function.
OPERATING YOUR WATER DISPENSER
The following steps apply only if you are switching from the Zerowater Bottle Kit to Standard
Delivery type water bottles.
Steps To Replace Water Bottles
Remove cap from the 5-gallon bottle and use a clean cloth to wipe off the neck of the bottle.
Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on
opening of bottle while placing in reservoir.
Place the 5-gallon bottle of water on the water intake, allow the water to stand for approximately 5
minutes.
Wipe off any water which may have splashed on dispenser top.
Control and Display Panel
For operation of unit, please fill water and make sure water settles inside the water tank, and then
switch on both hot and cold switches at back of unit.
To get hot water:
Slide red safety button to the right and hold
while pressing downward on hot water faucet
to dispense hot water.
Safety button will return to its original position
when faucet is released.
NOTE:
THE DISPENSING CAPACITY OF HOT WATER IS APPROXIMATELY 2 ½ CUPS AT A SINGLE
TIME. ONCE THE MAXIMUM NUMBER OF CUPS HAS BEEN DISPENSED THE RESERVOIR
WILL REFILL AND BE READY TO DISPENSE ANOTHER 2 ½ CUPS IN APPROXIMATELY 5 – 6
MINUTES
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.
When a new bottle is installed you must open the hot water faucet and remove no less than 4 full cups of
water to insure the water flows properly and the water reservoir is at the proper level.

   Find Your Products By Category