Cobra Electronics Marine Radio MRHH350FLT User Manual

0

Out of 0 Ratings

Owner's of the Cobra Electronics Marine Radio MRHH350FLT gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 34
 
31
Nothing Comes Close to a Cobra
®
Advanced Operation
Channel Scan Mode
During Channel Scan mode, the radio will rapidly switch
from channel to channel through all the channels.
NOTE
The radio must be squelched for Channel Scan mode
to function. See page 18 for Squelch procedure.
To Enter Channel Scan:
1. From Marine Standby mode, press the SCAN button.
The radio will immediately begin to scan the entire
channel map selected in the active channel map.
CHANNEL SCAN will display on the matrix.
2. A signal on any channel will stop the scan for 10
seconds to allow you to listen to the traffic on that
location. After 10 seconds, the radio will resume
scanning.
3. Press the Channel Up/Down button to resume
scanning before the 10-second pause has completed
or to change the scan direction.
4. To EXIT Channel Scan mode, press the SCAN button
again. The SCAN icon will disappear from the LCD
and the radio will return to Marine Standby mode.
VHF Marine Radio Protocols
Operating Your RadioVHF Marine Radio Protocols
30
English
Advanced Operation
To Recall a Stored Memory Location:
1. Press the MEM/ESC button. The MEM icon will be
turned On.
2. Press the Channel Up/Down button to select the
memory location. If a memory location has been
programmed, its associated channel will display on
the LCD. Your radio is now in Marine Standby mode
on the selected memory location.
To Exit Memory Location Mode:
Press the MEM/ESC button to return the radio to
Marine Standby mode. The last channel used in
Marine Standby mode will now be displayed on the
LCD and the MEM icon will disappear.
To Erase Stored Memory Locations:
1. Press and hold the MEM/ESC button for two (2)
seconds. The memory location number will be
displayed on the matrix and the MEM icon will be
turned On.
2. Use the Channel Up/Down button to advance to the
memory location you want to erase.
3. Press the MEM/ESC button to select the memory
location.
4. Use the Channel Up/Down button to change to the
channel to read “00” at the selected memory
location.
5. Press the MEM/ESC button to erase that channel.
Repeat steps 2 through 5 to erase as many additional
memories as you want.
6. Press and hold the MEM/ESC button for two (2)
seconds. This will return the radio to Memory mode.
7. Press and release the MEM/ESC button again to
return to Marine Standby mode.
SCAN
ESC
MEM
SCAN Button
MEMSAMEATIS VOX
LO MEDHI
VHF
T
R
A
B
GMRS
X
CIU
SCAN Icon
ENT SETUP
CALL
FLOATING MARINE HH350
Channel Up/Down Buttons
Operating Your Radio
MEMSAMEATIS VOX
LO MEDHI
VHF
T
R
A
B
GMRS
X
CIU
MEM Icon
350_VHF_Body_v8_MRHH330_ENG_Body 3/26/13 11:45 AM Page 30

   Find Your Products By Category