Furuno Radar Detector 1623 User Manual

3.9

Out of 2 Ratings

Owner's of the Furuno Radar Detector 1623 gave it a score of 3.9 out of 5. Here's how the scores stacked up:

  • Reliability

    4.5 out of 5

  • Durability

    4.0 out of 5

  • Maintenance

    3.5 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    3.5 out of 5
of 47
 
1. OPERATION
13
1.25 Resetting Distance Run
You may reset distance run to zero as below.
You need a navigator or speed log to display
distance run.
1. Press the [MENU/ESC] key to open the
User menu.
2. Press ▲ or ▼ to choose “TRIPLOG
RESET?” from page 3.
3. Press ► to open the options window.
4. Press ▲ to choose YES to reset distance
run.
5. Press the [MENU/ESC] key to close the
menu.
1.26 PROG Key
The [PROG] key acts as a menu shortcut key.
You may use any User menu item except
“TRIPLOG RESET?” and “SYSTEM MENU.”
Using the PROG key
1. Press the [PROG] key. The options
window corresponding to the item
programmed appears. In the example
below the echo stretch options window is
shown.
OFF
LOW
HIGH
ECHO STRETCH
Echo stretch options window
2. Press ▲ or ▼ to choose appropriate
option.
3. Press the [MENU/ESC] key to close the
options window.
Programming the PROG key
1. Press the [MENU/ESC] key to open the
User menu. “P” marks the current function
of the [PROG] key.
P
(1/3)
INT REJECTION LOW
ECHO STRETCH : LOW
FTC : OFF
NOISE REJECTION: LOW
[MENU/ESC] : Exit.
*
User menu, page 1
2. Press ▲ or ▼ to choose the item you
wish to use.
3. Press and hold down the [PROG] key
(about three seconds) until you hear a
beep. The “P” moves to the item selected.
4. Press the [MENU/ESC] key to close the
menu.
1.27 Outputting Target Position
to a Plotter
If the radar is interfaced with a plotter, you
can output target position to the plotter, and
show that position on the plotter’s screen with
the target mark (X). This function requires
position and heading data.
1. Use the cursor pad to place the cursor on
a target.
2. Press the [MARK] key to show the Mark
menu.
MARK MENU
[GAIN] : EBL
[ALARM] : VRM
[MARK] : TLL OUTPUT
Mark menu
3. Press the [MARK] key again to output
cursor position.
4. Press the [MENU/ESC] key to close the
menu.

   Find Your Products By Category