Furuno Radar Detector 1623 User Manual

3.9

Out of 2 Ratings

Owner's of the Furuno Radar Detector 1623 gave it a score of 3.9 out of 5. Here's how the scores stacked up:

  • Reliability

    4.5 out of 5

  • Durability

    4.0 out of 5

  • Maintenance

    3.5 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    3.5 out of 5
of 47
 
3. INSTALLATION
23
3. Using the hexagon head bolts, flat
washers and spring washers removed at
step 1, fasten the antenna unit to the
platform. The torque should be 19.6-24.5
N
•m. (If the thickness of the mounting
platform is greater than 10 mm, use
longer hex bolts (M10 x 25), considering
effective thread length from bottom of
antenna unit.)
Flat
washer
Antenna
base
Spring
washer
Platform
Hexagon head bolt
(M10 x 20)
5-10
mm
Effective
thread
length
16 mm
How to fasten the antenna
unit to the platform
4. Unfasten three screws to open the cover.
Release the cable of the rotation detector
from the cable clamp.
Cable
clamp
Rotation
detector
Cable
entrance
Antenna unit, cover removed, top view
5. Referring to the illustration at the top of
the next column for location, unfasten 11
screws to dismount the shield plate.
Discard the screw circled in the
illustration.
Shield plate
Discard this
screw.
Antenna unit, cover removed, top view
6. Pass the antenna cable with connector
through the gasket and cable clamp, and
then tighten cable gland. Two gaskets are
supplied: one gray, one black. Use the
proper gasket according to antenna cable
used, referring to the illustration below.
67
φ
12
49
φ
11
Use black gasket.
Use gray gasket.
Gasket (See below for
type to use.)
Rubber
Gasket
Cable Gland
Antenna unit, top view

   Find Your Products By Category