Chamberlain Garage Door Opener WD962KEV User Manual

5.0

Out of 1 Ratings

Owner's of the Chamberlain Garage Door Opener WD962KEV gave it a score of 5.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    5.0 out of 5
of 48
 
26
Option B
2.1B Cut the end of the safety
reversing sensor wire, making
sure there is enough wire to
reach the pre-installed wires
from the wall.
2.3B Connect the pre-installed wires to the sensor wires with wire nuts making sure the
colors correspond for each sensor. For example, the white wire would connect to
the yellow wire and the white/black wire would connect to the purple wire.
2.2B Separate the safety reversing sensor
wires and strip 7/16 inch (11 mm)
of insulation from each end. Choose
two of the pre-installed wires and
strip 7/16 inch (11 mm) of insulation
from each end. Make sure that you
choose the same color pre-installed
wires for each sensor.
7/16"
(11 mm)
7/16"
(11 mm)
Safety reversing sensor wires
Pre-installed
wires
Safety sensor wires
White
White/Black
Yellow
(for example)
Purple
(for example)
2.4B At the garage door opener, strip 7/16 inch (11 mm) of insulation from each end of
the wires previously chosen for the safety reversing sensors. Twist the like-colored
wires together.
2.5B Insert the wires connected to the white safety sensor wires to the white terminal
on the garage door opener. Insert the wires that are connected to the white/black
safety sensor wires to the grey terminal on the garage door opener.
Not Provided
7/16"
(11 mm)
Yellow
Purple
RED
WHITE
WHITE
GREY
WHITE
WHITE
ED
RED
RED
RE
WH
WHIT
Purple (for example)
Yellow (for example)
To insert or remove the wires
from the terminal, push in the
tab with a screwdriver tip.
Pre-installed
wires
Install the Protector System
®
PRE-WIRED INSTALLATION

   Find Your Products By Category