Atwood Mobile Products Water Heater Water Heater Exchanger User Manual

0

Out of 0 Ratings

Owner's of the Atwood Mobile Products Water Heater Water Heater Exchanger gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 40
 
16
Atwood 6 and 10 gallon Electronic Ignition Water Heaters
Atwood water heaters are designed and approved for use only in recreation vehicles (travel trailers, 5th wheels,
motor homes, etc.). They are offered in two sizes: 6 and 10 gallon capacities.
TYPE OF GAS IGNITION -
This unit is ignited inside of the trailer by a remote ON/OFF switch. The water temperature is preset at 140° F.
EXPLANATION OF MODEL NUMBER:
Electronic Models
GCH 6A - 9 E
Electronic Ignition
Version
Type of heating element
(GC_ A - _ _ = bolt on, GC_ A A-_ _ = screw in)
Gallon capacity (6 or 10)
Engine heat exchange
Combination gas and 110VAC electric
Propane Gas
NOTE: When replacing the element on a combination gas/110 VAC unit, always check the back
of the heater for the type of element it has. It will either be a bolt-on or screw-in
element. They are not interchangeable.
FEATURES
•
All units operate on propane gas.
•
A pre-set thermostat set for 140° F. An aftermarket retro-fit adjustable thermostat is available and
adjustable from 110° to 150° F.
•
A heat exchange option is available. The water heater tank must have factory equipped heat exchange
tubes welded on it already. They cannot be added later. A new water heater tank with this feature must be
installed to use the heat exchanger.
•
Skin mounting allows the water heater to be hooked up with plumbing and electrical before the sidewall is
erected.
•
This heater has a comparable, if not superior, anode type protection for the tank. The tank is manufactured
with a clad aluminum lining that protects against corrosion but does not need to be replaced yearly as an
anode rod. A more detailed explanation of cladding is found in the back of this manual.
•
95% of all servicing is done on the outside of the water heater. 110 VAC heating components are the
exception. Since they are located on the back of the water heater inside the trailer.
•
A flush flange is available for all models. This makes the access door flush with the sidewall.
•
There are multiple protection features in the form of a pressure-temperature relief valve, a limit switch in
the gas thermostat and an externally sealed combustion chamber.
•
Both the six and ten gallon units have the lightest weight in the industry.
•
On all trailers purchased after June 1, 1997 the Atwood Limited Warranty is for a period of two years. This
includes all reasonable labor charges.
•
We have 700+ Service Centers throughout the United States.

   Find Your Products By Category