Atwood Mobile Products Water Heater Water Heater Exchanger User Manual

0

Out of 0 Ratings

Owner's of the Atwood Mobile Products Water Heater Water Heater Exchanger gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 40
 
7
Recommended Tools and Equipment
U-Tube Manometer - This is the most accurate device for measuring gas pressure. If you use a dial-type
manometer, it should be calibrated periodically with this type of manometer.
Thermostat Wrench - This tool allows for easier and safer removal of the gas thermostat control. An
adjustable version for different size controls is available through most RV distributors or you may fabricate one
from angle iron. We do not recommend using a pipe wrench because it may damage the control causing it to
go out of calibration.
Multi-meter - This is the most versatile meter and will test AC voltage and continuity. A continuity test can be
used to test for a blown E.C.O. on a gas control.
Magnet Assembly Thermocouple Tester - This assembly can be obtained at an electronics or hardware store.
This same assembly can also be removed from a Robertshaw control. It will verify if a thermocouple is good.
For testing, screw a thermocouple into the tester, heat the thermocouple for 25 seconds and then press the
plunger down. If the plunger pops up in less that 25 seconds, the thermocouple is faulty.
Common Hand Tools - 1/8˝ and 1/4˝ nut drivers, open end wrenches, flat blade and Phillips screw drivers.
Leak Test Solution - A solution that bubbles when applied to gas fittings or connections showing when a gas
leak is present.
THERMOSTAT WRENCH
7
6
5
4
3
2
1
0
1
2
3
4
5
6
7
Manometer
connection
Correct
water
level
Fill here
U-TUBE MANOMETER
with 1/8” pipe nipple
MULTI-METER TO TEST
AC VOLTAGE AND CONTINUITY
MAGNET ASSEMBLY TO TEST
THERMOCOUPLE

   Find Your Products By Category