Bogen Pager UTI312 User Manual

0

Out of 0 Ratings

Owner's of the Bogen Pager UTI312 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 32
 
Installation
Mounting
Wall Mounting
Mounting to a plywood backboard or studs:
1. On each side remove the four screws in the corners and use them to
attach the mounting flanges so that the flanges are facing the rear of the
unit.
2. Hold the unit level against the surface to which it will be mounted.
3. Using the keyholes,mark on the mounting surface where the mounting
screws (not included) should be positioned.
4. Set the unit aside and install the screws leaving about
1
/4" of the screws
sticking out of the surface.
5. Slip the unit over the screws through the keyholes and let the unit rest
on the screws.Tighten screws snugly.
Rack Mounting, Flush
Mounting flush to a rack:
1. On each side remove the four screws in the corners and use them to
attach the mounting flanges so that the flanges are facing the front of
the unit.
2. Attach unit to rack with 4 rack screws (not supplied). Do not use
keyholes for mounting to a rack.
Rack Mounting, Recessed for Wire Access
Recessed in a rack to allow for top or bottom wire entry:
1. On each side remove the four screws in the corners and use them to
mount the mounting flanges so that the flanges are protruded from the
front of the unit.This recess allows enough space for wire access from
top or bottom.
2. Attach unit to rack with 4 rack screws (not supplied). Do not use
keyholes for mounting to a rack.
ZX3 Module Installation & Jumper Selections
The UTI312 module bay can accommodate up to four ZX3 modules. Each
ZX3 module has 3 zone outputs giving the UTI312 a capacity of up to 12
paging zones.
Each module slot is marked on the lower left hand corner indicating which
zones correspond with each slot.
To install, first select each zone’s Music Bus A or B or (no music) using the
jumpers, then slide the ZX3 module into the card guides and push the
module all the way home. Secure with mounting screws.
6
Wall Mounting
Rack Mounting,Wire Access
Rack Mounting, Flush
ZX3 BGM Jumper Selections

   Find Your Products By Category