0

Out of 0 Ratings

Owner's of the Bushnell Hunting Equipment Bushnell Hunting Equipment gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 212
 
11
photos or videos automatically (according to its current parameter settings)
when it is triggered by the PIR sensor’s detection of activity in the area it
covers.
You can either move the power switch directly from OFF to ON mode, or
stop at the SETUP position first to change one or more settings, then move
the switch to ON after you have finished doing so.
SETUP MODE
In the SETUP mode you can check and change the settings of the
NatureView Cam with the help of its built-in LCD (or a monitor connected to
the TV out jack). These settings, found in the SETUP Menu, let you change the
photo or video resolution, interval between photos, switch the time imprint
on, etc. Moving the power switch to the SETUP position will turn on the
LCD display, and you will see an information screen that shows how many
images have been taken, the battery level, camera or video mode, etc (Fig.
3, next page).
NOTE: Always move the power switch from OFF to SETUP mode. It is
possible that the camera could lockup if it is switched from ON to SETUP
mode. If this occurs, simply move the switch to OFF and then push it up to
SETUP again.
SETUP Mode Shortcut Keys/Functions
As mentioned earlier in “Parts & Controls”, four of the keys below the LCD
have secondary, “shortcut” functions when the camera is switched to
SETUP mode (but the MENU key has not been pressed):
• Press the UP key to quickly set the camera to shoot video clips.
• Press the DOWN key to quickly set the camera to take still photos.
• Press the RIGHT key to manually trigger the shutter. This is useful
for testing the camera-make sure you are in SETUP mode, press the
RIGHT key, and a few seconds later a photo or video (depending on
how the camera was set) will be saved to the SD card (or internal
memory if no card is inserted). The “number of images taken” counter
on the bottom left of the LCD will increase by one. If the display
indicates “SD PROTECTED” when you press the SHOT key, switch
the camera OFF, remove the SD card and slide its protect switch off.
• Press the OK key to replay (review or playback) photos/videos on a
connected TV monitor. See “Playing Back/Deleting the Photos/Videos”
(pg. 29) for more details.